-
With the main breaker on and the generator breaker off, place the interlock over the main breaker. The tab on the inside upper right corner of the interlock should be against the right side of the main breaker toggle and the tab at the bottom of the interlock should be just to the left of the generator breaker toggle. Mark the position of the bottom plate.
-
Disassemble the interlock and place the bottom plate back in the same position Mark the
position of holes onto the panel cover.
-
Remove panel cover and drill holes using the
supplied 3/16" drill bit.
-
With the screws inserted through the back of the panel
cover, reassemble the interlock.
-
Be sure the top plate of the interlock can slide left
and right.
-
Replace panel box cover.
-
Remove warning sticker from this sheet and place
vertically across the generator double
breaker.